2014 Hilux · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

AT05437E01
  1. Inspect the 1-way clutch.

    1. Install SST in the inner race of the 1-way clutch.

      SST
      09350-32014   (09351-32020)

    2. Press on the serrations of the starter with a finger and rotate it.
      Check that it rotates smoothly when turned clockwise and locks when turned counterclockwise.
      If the results are not as specified, clean the converter and recheck the 1-way clutch. If the results still are not as specified, replace the torque converter clutch assembly.

  1. D025367E04
    Determine the condition of the torque converter clutch.

    1. Check that the following conditions are met:

      1. During the stall test or when the shift lever is on N, metallic sounds are not emitted from the torque converter clutch.
      2. The one-way clutch turns in one direction and locks in the other direction.
      3. The amount of powder in the ATF is not greater than the sample shown in the illustration.
      If the results are not as specified, replace the torque converter clutch assembly.

      HINT:
      The sample illustration shows approximately 0.25 liters (0.26 US qts, 0.22 Imp. qts) of the ATF taken from a removed torque converter clutch.

  1. Replace the ATF in the torque converter clutch.

    1. If the ATF is discolored and/or has a foul odor, stir the ATF in the torque converter clutch thoroughly and drain the ATF with the torque converter facing up.

  1. C011090E01
    Clean and check the oil cooler and oil pipe line.

    1. If the torque converter clutch is inspected or the ATF is replaced, clean the oil cooler and oil pipe line.

      HINT:
      1. Apply compressed air of 196 kPa (2 kgf/cm2, 28 psi) into the inlet hose.
      2. If a large amount of powder is found in the ATF, add new ATF using a bucket pump and clean the oil cooler and oil pipe line again.

    2. If the ATF is cloudy, inspect the oil cooler (radiator).

  1. D025368E05
    Prevent deformation of the torque converter clutch and damage to the oil pump gear.

    1. When any marks due to interference are found on the end of the bolt for the torque converter clutch and on the bottom of the bolt hole, replace the bolt and torque converter clutch.

    2. All of the bolts should be the same length.

    3. Make sure no spring washers are missing.


INSPECT DRIVE PLATE
  1. Check the drive plate for damage.

  1. C193826E01
    Set up a dial indicator and measure the runout of the 6 portions around the torque converter fitting surfaces.

    Maximum runout:
    0.3 mm (0.0118 in.)

    If the runout is more than the maximum or if the ring gear is damaged, replace the drive plate (See page 1GR-FE: Click here 1KD-FTV: Click here).

← INSTALLATION (from Aug 2013)COMPONENTS (from Nov 2011) →