REMOVAL
Removal / installation · Vehicles built from Jun 2011
- NOTICE:
- When using a vise, do not overtighten it.
- When installing, coat the parts indicated by the arrows with power steering fluid (Click here).
- When using a vise, do not overtighten it.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FAN & GENERATOR V BELT |
![]() ![]() |
While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.
| 3. DRAIN POWER STEERING FLUID |
| 4. DISCONNECT OIL RESERVOIR TO PUMP HOSE |
![]() ![]() |
Disengage the clip and disconnect the hose.
| 5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY |
![]() ![]() |
Remove the union bolt, then disconnect the pressure feed tube.
Remove the gasket from the pressure feed tube.
| 6. REMOVE VANE PUMP ASSEMBLY |
![]() ![]() |
Disconnect the oil pressure switch connector.
Remove the bolt and wire harness clamp bracket.
Remove the 2 bolts and vane pump.





