DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. FIX VANE PUMP ASSEMBLY |
![]() ![]() |
Using SST, fix the vane pump in a vise.
- SST
- 09630-00014
(09631-00132)
| 2. REMOVE POWER STEERING SUCTION PORT UNION |
Remove the bolt and suction port union.
Remove the O-ring from the suction port union.
| 3. REMOVE FROW CONTROL VALVE |
Remove the pressure port union.
Remove the O-ring from the pressure port union.
Remove the flow control valve and compression spring.
| 4. REMOVE POWER STEERING OIL PRESSURE SWITCH |
- NOTICE:
- Be careful not to drop or badly damage the oil pressure switch. If damaged, replace it with a new one.
| 5. REMOVE REAR VANE PUMP HOUSING |
Remove the 4 bolts and rear vane pump housing from the front vane pump housing.
Remove the O-ring from the front vane pump housing.
| 6. REMOVE SHAFT SUB-ASSEMBLY WITH PULLEY |
- NOTICE:
- Be careful not to drop or badly damage the pulley shaft. If damaged, replace it with a new one.
Using a screwdriver, remove the snap ring from the pulley shaft.
Remove the pulley shaft.
| 7. REMOVE VANE PUMP ROTOR |
Remove the 10 vane plates.
Remove the vane pump rotor.
| 8. REMOVE VANE PUMP CAM RING |
| 9. REMOVE FRONT VANE PUMP SIDE PLATE |
![]() ![]() |
Remove the side plate from the front vane pump housing.
Remove the O-ring from the side plate.
Remove the O-ring from the front vane pump housing.

| 10. REMOVE VANE PUMP HOUSING OIL SEAL |
![]() ![]() |
Using a screwdriver, pry out the oil seal.
- NOTICE:
- Be careful not to damage the front vane pump housing.



