2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL STARTER ASSEMBLY

  1. for Automatic Transmission:

    1. A122692E02
      Connect the ground cable and install the starter assembly with the 2 nuts and bolt.

      Torque:
      68 N*m{ 693 kgf*cm , 50 ft.*lbf }

      Text in Illustration 
      *1
      Ground Cable

      HINT:
      Make sure to connect the ground cable with the nut as shown in the illustration.

  1. for Manual Transmission:

    1. A287490E01
      Connect the ground cable and install the starter assembly with the nut and bolt.

      Torque:
      68 N*m{ 693 kgf*cm , 50 ft.*lbf }

      Text in Illustration 
      *1
      Ground Cable

      HINT:
      Make sure to connect the ground cable with the nut as shown in the illustration.

  1. Install the starter wire to terminal 30 with the nut.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the starter connector.


2. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

G039346E01
  1. Coat a new O-ring with ATF, and install it to the oil filler tube.

  1. Coat a new O-ring with ATF, and install it to the oil filler tube.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Install the oil level gauge.


3. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

G034223E01
  1. Install the release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }


4. INSTALL FRONT FENDER SEAL
  1. Install the front fender seal with the 5 clips.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →