REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE AIR CLEANER ASSEMBLY |
Disconnect the IAT sensor connector.

Loosen the air cleaner hose clamp.
Remove the 2 bolts and air cleaner.
| 3. REMOVE COOLER COMPRESSOR V BELT (w/ Air Conditioning System) |
Loosen the nut A and bolt B, and remove the V belt.

| 4. REMOVE FAN & GENERATOR V BELT (w/ Air Conditioning System) |
Loosen the bolts A and B.

Loosen the adjusting bolt C, and remove the V belt.
| 5. REMOVE FAN & GENERATOR V BELT (w/o Air Conditioning System) |
Loosen the bolts A and B, and remove the V belt.

| 6. REMOVE FAN BELT ADJUSTING BAR (w/o Air Conditioning System) |
Remove the 3 bolts and fan belt adjusting bar.

| 7. DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System) |
Disconnect the compressor connector.

Remove the 4 bolts and disconnect the cooler compressor.
- HINT:
- It is not necessary to completely remove the compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.
| 8. REMOVE COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System) |
Remove the bolt and spacer.

Remove the 4 bolts and compressor mounting bracket.

| 9. REMOVE GENERATOR ASSEMBLY |
![]() ![]() |
Disconnect the terminal cap.
Remove the nut and generator wire.
Disconnect the generator connector.
Remove the union bolt to disconnect the vacuum pump hose and remove the 2 gaskets.

Remove the union bolt to disconnect the vacuum pump oil inlet hose and remove the 2 gaskets.
Detach the vacuum pump oil inlet hose from the cord clip.
Disconnect the vacuum pump oil outlet hose.
Remove the bolt and generator.


