INSTALLATION
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL GLOW PLUG ASSEMBLY |
![]() ![]() |
Using a 12 mm deep socket wrench, install the 4 glow plugs.
- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
| 2. INSTALL NO. 1 GLOW PLUG CONNECTOR |
Install the glow plug connector by uniformly tightening the 4 nuts.
- Torque:
- 2.2 N*m{ 22 kgf*cm , 19 in.*lbf }
Install the 4 screw grommets.
Install the wire harness with the nut.
- Torque:
- 2.0 N*m{ 20 kgf*cm , 18 in.*lbf }
| 3. INSTALL INTAKE AIR CONNECTOR |
![]() ![]() |
Install a new gasket and the air connector with the 2 nuts and bolt.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
| 4. INSTALL THROTTLE BODY BRACKET |
Install the bracket with the 3 bolts.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
| 5. INSTALL DIESEL THROTTLE BODY ASSEMBLY |
![]() ![]() |
Install a new gasket and the throttle body with the 2 bolts and 2 nuts.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
Connect the 2 connectors.

| 6. INSTALL VACUUM SWITCHING VALVE BRACKET |
![]() ![]() |
Install the bracket with the 2 bolts.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
| 7. INSTALL NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY |
![]() ![]() |
Connect the pipe (with the 2 air hoses) and install the bolt.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
Tighten the 2 clamps.
Connect the vacuum hose to the gas filter.
Connect the manifold absolute pressure sensor connector.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. PERFORM INITIALIZATION |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.





