2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL GLOW PLUG ASSEMBLY

A111830
  1. Using a 12 mm deep socket wrench, install the 4 glow plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }


2. INSTALL NO. 1 GLOW PLUG CONNECTOR
  1. Install the glow plug connector by uniformly tightening the 4 nuts.

    Torque:
    2.2 N*m{ 22 kgf*cm , 19 in.*lbf }

  1. Install the 4 screw grommets.

  1. Install the wire harness with the nut.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


3. INSTALL INTAKE AIR CONNECTOR

A114779
  1. Install a new gasket and the air connector with the 2 nuts and bolt.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


4. INSTALL THROTTLE BODY BRACKET
  1. Install the bracket with the 3 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


5. INSTALL DIESEL THROTTLE BODY ASSEMBLY
  1. Install a new gasket and the diesel throttle body assembly with the 2 bolts and 2 nuts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the 2 connectors.


6. INSTALL VACUUM SWITCHING VALVE BRACKET

A114103
  1. Install the bracket with the 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


7. INSTALL NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY
  1. Connect the pipe (with the 2 air hoses) and install the bolt.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Tighten the 2 clamps.

  1. Connect the vacuum hose to the gas filter.

  1. Connect the manifold absolute pressure sensor connector.

  1. w/ No. 1 Engine Cover

    1. Install the engine cover bracket with the 2 bolts.

      Torque:
      18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    2. Attach the 4 claws to the pins of the engine cover bracket and install the No. 1 engine cover sub-assembly.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

← INSTALLATION (Aug 2012 – Jul 2013)COMPONENTS (from Jun 2011) →