2014 Hilux · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2013

HINT:
Use these procedures to troubleshoot the rear view monitor system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CHECK DTC OF NAVIGATION SYSTEM
      1. Refer to DTC Check/Clear procedures of the navigation system (Click here).

        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      4.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B

      B.
      A

      5.SYMPTOM SIMULATION
        NEXT

        6.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM
        1. Refer to the navigation system (Click here).

          Result 
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears
          B


        B.
        A

        7.PROBLEM SYMPTOMS TABLE
        1. Refer to the problem symptoms table (Click here).

          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        A

        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here).

        NEXT

        9.ADJUST, REPAIR OR REPLACE
          NEXT

          10.CONFIRMATION TEST
            NEXT

            ← SYSTEM DESCRIPTION (from Aug 2013)PROBLEM SYMPTOMS TABLE (from Aug 2013) →