2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT VACUUM SWITCHING VALVE (for EGR Bypass Valve)
  1. Inspect the vacuum switching valve.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      37 to 44 Ω
      1 - Body ground
      2 - Body ground
      20°C (68°F)
      10 kΩ or higher

      If the result is not as specified, replace the vacuum switching valve.

  1. A222591E03
    Check operation of the vacuum switching valve.

    1. When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.

      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Filter
      *a
      Air
      *b
      Vacuum

    2. A222592E03
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *a
      Air

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the vacuum switching valve.

← REMOVAL (from Jun 2011)INSTALLATION (from Jun 2011) →