INSTALLATION
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1.
INSTALL AIR PUMP ASSEMBLY |
 |
- Install the pump to the bracket with air pump insulator.
| 2.
CONNECT NO. 3 AIR HOSE |
 |
- Connect the No. 3 hose to the pump.
| 3.
CONNECT NO. 2 AIR HOSE |
 |
Connect the No. 2 hose to the pump.
Secure the No. 2 hose with the clamp.
- HINT:
- The clamp can be installed facing upward or downward.
Clamp the No. 2 hose and wire harness with the clamp.
| 4.
INSTALL AIR PUMP COVER |
 |
- Install the cover to the bracket with the 3 clips.
| 5.
INSTALL AIR PUMP PIPE |
 |
- Install the inlet pipe to the body panel with the bolt.
-
Torque:
- 13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
| 6.
INSTALL AIR PUMP ASSEMBLY WITH BRACKET |
 |
- Install the pump with bracket to the body panel with the 3 bolts.
-
Torque:
- 13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
- HINT:
- Attach the bracket's protrusion to the body's hole.
Connect the No. 2 and No. 3 hoses to the inlet pipe.
- HINT:
- Connect the No. 2 air hose to the pipe connected to the air switching valve.
Secure the No. 2 hose with the clamp.
- Install the 2 claws to the inlet pipe and body panel.
Connect the connector.
| 7.
INSTALL FRONT FENDER APRON SEAL UPPER |
 |
Install the apron seal with the 6 clips.
| 8.
CONNECT NO. 4 AIR HOSE |
 |
- Connect the No. 4 hose to the air switching valve and inlet pipe.
Secure the hose with the 2 clamps.
Clamp the hose with the clamp.
| 9.
INSTALL AIR PUMP INLET |
 |
Connect the hose to the inlet pipe.
Install the pump inlet to the radiator tank upper with the bolt.
-
Torque:
- 8.5 N*m{
87 kgf*cm
, 75 in.*lbf
}
| 10.
INSTALL AIR CLEANER ASSEMBLY |
 |
- Connect the air cleaner hose.
Install the air cleaner with the 2 bolts.
-
Torque:
- 14 N*m{
143 kgf*cm
, 10 ft.*lbf
}
Tighten the hose clamp.
-
Torque:
- 4.0 N*m{
41 kgf*cm
, 35 in.*lbf
}
Connect the MAF meter connector.
| 11.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 12.
PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.