REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE AIR CLEANER ASSEMBLY |
 |
- Disconnect the MAF meter connector.
Loosen the hose clamp.
Remove the 2 bolts and air cleaner.
| 3.
REMOVE AIR PUMP INLET |
 |
- Remove the bolt from the radiator tank upper.
Disconnect the hose from the air pump inlet pipe.
| 4.
DISCONNECT NO. 4 AIR HOSE |
 |
Disconnect the hose from the clamp.
Loosen the 2 clamps and disconnect the No. 4 air hose.
| 5.
REMOVE AIR PUMP PIPE |
 |
- Disconnect the connector.
Using a clip remover, remove the 2 claws from the body panel and inlet pipe.
Remove the bolt and inlet pipe.
| 6.
REMOVE FRONT FENDER APRON SEAL UPPER |
 |
Remove the 6 clips and apron seal.
| 7.
REMOVE AIR PUMP ASSEMBLY WITH BRACKET |
 |
- Disconnect the No. 3 hose from the inlet pipe.
Loosen the clamp and disconnect the No. 2 hose from the inlet pipe.
Remove the 3 bolts and pump.
| 8.
REMOVE AIR PUMP COVER |
 |
- Using a clip remover, detach the 3 clips and remove the pump cover.
| 9.
DISCONNECT NO. 2 AIR HOSE |
 |
- Remove the clamp from the No. 2 hose.
Loosen the clamp and disconnect the No. 2 hose from the pump.
| 10.
DISCONNECT NO. 3 AIR HOSE |
 |
Disconnect No. 3 hose from the pump.
| 11.
REMOVE AIR PUMP ASSEMBLY |
 |
- Remove the pump from the bracket with air pump insulator.