2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


INSPECT INTAKE MANIFOLD (w/ Intercooler)

A149794

NOTICE:
Do not adjust the adjusting screw or 2 actuator installation bolts.

  1. A149796E03
    Disconnect the vacuum hose from the actuator.
    Text in Illustration 
    *a
    Disconnect

  1. Check the operation of the swirl control valve.

    1. Check that the valve is fully opened under normal conditions.

    2. Connect a vacuum pump to the control valve. Check that the valve is fully closed when a negative pressure of 35 kPa (263 mmHg, 10 in.Hg) is applied.

    3. Leave it for 1 minute and check that the vacuum pump needle does not move.
      If the result is not as specified, replace the intake manifold.


INSPECT VACUUM SWITCHING VALVE (for Swirl Control Valve)
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    33 to 39 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    10 kΩ or higher

    If the result is not as specified, replace the intake manifold.

  1. G037162E03
    Check the operation according to the value(s) in the table below.
    Text in Illustration 
    *1
    Port E
    *2
    Air Filter
    V100135
    Airflow

    1. Check that air flows from port E to the filter.
      If the result is not as specified, replace the intake manifold.

    2. A110309E04
      Apply battery voltage across the terminals.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      V100135
      Airflow

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the intake manifold.

← INSPECTION (Jun 2011 – Jul 2012)INSTALLATION (Jun 2011 – Jul 2012) →