2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


INSPECT INTAKE MANIFOLD (w/ EGR Cooler)

A149794

NOTICE:
Do not adjust the adjusting screw or 2 actuator installation bolts.

  1. A149796E01
    Disconnect the vacuum hose from the actuator.

  1. Check the operation of the swirl control valve.

    1. Check that the valve is fully opened under normal conditions.

    2. Connect a vacuum pump to the control valve. Check that the valve is fully closed when a negative pressure of 35 kPa (270 mmHg, 10 in.Hg) is applied.

    3. Leave it for 1 minute and check that the vacuum pump needle does not move.
      If the result is not as specified, replace the intake manifold.


INSPECT VACUUM SWITCHING VALVE (for Swirl Control Valve)

  1. A110308E03
    Measure the resistance of the VSV.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    33 to 39 Ω at 20°C (68°F)
    1 - Body ground
    2 - Body ground
    10 kΩ or higher

    If the result is not as specified, replace the intake manifold.

  1. G037162E01
    Check the operation of the VSV.

    1. Check that air flows from port E to the filter.
      If the result is not as specified, replace the intake manifold.

    2. A110309E01
      Apply battery voltage across the terminals.

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the intake manifold.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2012) →