2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A110362
    Remove the 3 bolts, 2 nuts and cover.


3. REMOVE CHARGE AIR COOLER ASSEMBLY WITH INTAKE AIR CONNECTOR
  1. Remove the charge air cooler with intake air connector (Click here).


4. REMOVE VACUUM SWITCHING VALVE BRACKET

  1. A110298
    Disconnect the 2 connectors.

  1. Disconnect the vacuum hoses from the 3 locations.

  1. Remove the 2 bolts and bracket.


5. REMOVE DIESEL THROTTLE BODY ASSEMBLY

  1. A111790
    Disconnect the 2 connectors.

  1. A111832
    Remove the 2 bolts, 2 nuts, throttle body and gasket.


6. REMOVE THROTTLE BODY BRACKET

  1. A110300
    Remove the 3 bolts and bracket.


7. REMOVE INTAKE AIR CONNECTOR
  1. Remove the 2 nuts, bolt, air connector and bracket.


8. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY

A099621E01
  1. Remove the 2 bolts, 2 nuts, pipe and 2 gaskets.


9. REMOVE EGR VALVE ASSEMBLY
  1. Remove the EGR valve and gasket.


10. REMOVE MANIFOLD STAY

A099622E01
  1. Remove the 2 bolts and stay.


11. REMOVE OIL LEVEL GAUGE GUIDE

A099624E01
  1. Remove the bolt and injection pipe clamp.

  1. Remove the bolt and guide.

  1. Remove the O-ring from the guide.


12. REMOVE INJECTION PIPE SUB-ASSEMBLY

NOTICE:
  1. After removing the fuel pipe, cover the outlets on the common rail with tape to keep out foreign matter.
  2. After removing the fuel pipe, put it in a plastic bag to prevent foreign matter from contaminating its injector inlet.

  1. A231803E01
    Remove the bolt and No. 2 injection pipe clamp.

  1. Remove the 2 nuts and No. 3 injection pipe clamp.

  1. Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 1, No. 2 and No. 3 injection pipes.


13. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
  1. Disconnect the 3 fuel hoses.

  1. A098898E05
    Remove the union bolt, 3 bolts, No. 2 nozzle leakage pipe and gasket.


14. REMOVE INTAKE MANIFOLD

A099626E01
  1. Disconnect the vacuum hose.

  1. Disconnect the VSV connector.

  1. Remove the 2 nuts, 4 bolts, intake manifold and gasket.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →