2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A110362
    Remove the 3 bolts, 2 nuts and cover.


3. REMOVE NO. 1 GAS FILTER

  1. A110363
    Remove the bolt and filter.


4. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR

  1. A110364
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.


5. REMOVE CHARGE AIR COOLER ASSEMBLY

  1. A110365
    Disconnect the diesel turbo IAT sensor connector.

  1. Loosen the 2 hose clamps of the No. 1 air hose.

  1. A110366
    Loosen the 2 hose clamps of the No. 2 air hose.

  1. A110367
    Remove the 4 bolts and CAC.

  1. A112149
    Using a 22 mm deep socket wrench, remove the IAT sensor.

    HINT:
    Replace the IAT sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the IAT sensor each time the CAC is replaced.

  1. A112150
    Remove the 4 bolts, intake air connector and gasket.

← COMPONENTS (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →