2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


1. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)

2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A112147E01


3. REMOVE RADIATOR GRILLE

  1. B277710E01
    Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 clips and 2 screws.

  1. B277711
    Detach the 6 claws and remove the radiator grille.


4. REMOVE RADIATOR SIDE DEFLECTOR LH
  1. Using a clip remover, remove the 3 clips.

  1. Detach the claw and remove the radiator side deflector LH.


5. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 3 clips.

  1. Detach the claw and remove the radiator side deflector RH.


6. DISCONNECT RADIATOR HOSE INLET
  1. Disconnect the radiator hose inlet from the radiator.


7. DISCONNECT RADIATOR HOSE OUTLET
  1. Disconnect the radiator hose outlet from the radiator.


8. REMOVE FAN SHROUD

  1. A110387
    Remove the 3 bolts and oil reservoir.

  1. A252176
    Disconnect the No. 1 and No. 2 water by-pass hoses from the radiator.

  1. Remove the 2 bolts and radiator reservoir.

  1. Loosen the 4 nuts holding the fluid coupling with fan.

  1. Remove the fan and generator V belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling with fan, and then remove the fan shroud together with the fluid coupling with fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the engine water pump.


9. DISCONNECT NO. 1 OIL COOLER TUBE INLET (for Automatic Transmission)
  1. Disconnect the No. 1 oil cooler tube inlet from the radiator.


10. DISCONNECT NO. 1 OIL COOLER TUBE OUTLET (for Automatic Transmission)
  1. Disconnect the No. 1 oil cooler tube outlet from the radiator.


11. REMOVE RADIATOR ASSEMBLY

A097639E01
  1. Remove the 4 bolts and radiator.

← REMOVAL (Jun 2011 – Jul 2012)DISASSEMBLY (Jun 2011 – Jul 2012) →