2014 Hilux · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:
  1. It is only necessary to perform this procedure when replacing a No. 1 roof drip side finish moulding clip with a new one.
  2. If installing new No. 1 roof drip side finish moulding clips, remove the adhesive remaining where the No. 1 roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with a non-residue solvent.

HINT:
When installing the No. 1 roof drip side finish moulding clip, heat the vehicle body and No. 1 roof drip side finish moulding clip using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
No. 1 Roof Drip Side Finish Moulding Clip
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or No. 1 roof drip side finish moulding clip excessively.

  1. B187426E02
    Apply a 2.0 to 3.0 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new No. 1 roof drip side finish moulding clips.

    HINT:
    Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm2, 1991 psi) or more (when the temperature is 23°C (73°F))

    Text in Illustration 
    *1
    Adhesive
    *a
    2 to 3 mm Bead of Adhesive

  1. Apply primer to the body where the No. 1 roof drip side finish moulding clip will be installed.

    NOTICE:
    Do not let the primer dry.

  1. B277526E01
    While using the position shown in the illustration as a reference, place the No. 1 roof drip side finish moulding clip onto the roof panel. Then position and install the No. 1 roof drip side finish moulding clip after lightly pressing it so that the adhesive adheres to the primer.
    Text in Illustration 
    *A
    for Single Cab
    *B
    for Double Cab
    *C
    for Extra Cab

    Standard:
    Area
    Measurement (Reference Value)
    A
    40.7 mm (1.60 in.)
    B
    47.6 mm (1.87 in.)
    C
    40.7 mm (1.60 in.)
    D
    39.2 mm (1.54 in.)
    E
    40.7 mm (1.60 in.)
    F
    42.9 mm (1.69 in.)

    NOTICE:
    Install the roof drip side finish moulding when 40 minutes or more have elapsed after pressing and installing the No. 1 roof drip side finish moulding clips.

    HINT:
    1. Initial hardening time: 40 minutes
    2. Complete hardening time: 48 hours


2. INSTALL ROOF DRIP SIDE FINISH MOULDING LH
  1. Attach the 2 clips to install the roof drip side finish moulding.

← REMOVAL (from Jun 2011)COMPONENTS (from Jun 2011) →