REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE RADIATOR GRILLE
|
 |
- Put protective tape around the radiator grille.
Text in Illustration
*1
|
Protective Tape
|
Remove the 2 clips and 2 screws.
- Detach the 6 claws and remove the radiator grille.
| 3.
REMOVE RADIATOR SIDE DEFLECTOR LH |
 |
- Using a clip remover, remove the 2 clips.
Detach the claw and remove the deflector.
| 4.
REMOVE RADIATOR SIDE DEFLECTOR RH |
 |
Using a clip remover, remove the 2 clips.
Detach the claw and remove the deflector.
| 5.
DRAIN ENGINE COOLANT
|
 |
Remove the radiator cap.
Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.


| 6.
REMOVE RADIATOR HOSE INLET |
|
| 7.
REMOVE RADIATOR HOSE OUTLET |
|
| 8.
REMOVE FAN SHROUD |
 |
Disconnect the reservoir hose from the radiator tank upper.
Loosen the 4 nuts holding the fluid coupling fan.
Remove the drive belt (Click here).
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
- NOTICE:
- Be careful not to damage the radiator core.
Remove the fan pulley from the water pump.
| 9.
REMOVE RADIATOR ASSEMBLY |
 |
- Disconnect the 2 airbag sensor front connectors.
Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.
- HINT:
- Tape the clip remover tip before use.
- Remove the 4 bolts and radiator.