DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1.
REMOVE RADIATOR BRACKET SUB-ASSEMBLY |
 |
- Remove the 4 bolts and 2 brackets.
| 2.
REMOVE RADIATOR DRAIN COCK PLUG |
 |
Remove the drain plug.
Remove the O-ring.
| 3.
ASSEMBLE SST |
 |
- Install the claw to part A of the overhaul handle as shown in the illustration.
- SST
- 09230-01010
(09231-01010, 09231-01030)
While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.
- Dimension B:
- 0.2 to 0.3 mm (0.008 to 0.012 in.)
- NOTICE:
- If this adjustment is not performed, the claw will be damaged.
| 4.
UNCAULK LOCK PLATE |
 |
- Using SST to release the caulking, squeeze the handle until stopped by the stopper bolt.
- SST
- 09230-01010
(09231-01010, 09231-01030)
| 5.
REMOVE RADIATOR TANK UPPER AND TANK LOWER |
 |
- Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a plastic-faced hammer and remove the tank.
Remove the O-ring.