2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


1. DISCONNECT NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and under cover.


3. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.

  1. Loosen the 2 cylinder block drain cock plugs and radiator drain plug, and then the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A110401E01


4. REMOVE V-BANK COVER

  1. A112983
    Remove the 2 nuts and the V-bank cover.


5. DISCONNECT RADIATOR HOSE INLET

6. DISCONNECT RADIATOR HOSE OUTLET

7. REMOVE FAN SHROUD

A112136
  1. Disconnect the radiator reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the driver belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.


8. DISCONNECT NO. 2 VENTILATION HOSE

A075594

9. REMOVE AIR CLEANER ASSEMBLY

  1. A075595
    Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Remove the 2 wire harness clamps.

  1. A075596
    Loosen the 2 hose clamps.

  1. Remove the 2 bolts and air cleaner.


10. REMOVE WATER INLET HOUSING

A076335E01
  1. Disconnect the 2 radiator hoses.

  1. A076336E01
    Disconnect the 5 water by-pass hoses.

  1. A076337E01
    Remove the 5 bolts and water inlet.

  1. Remove the O-ring from the water outlet pipe.

  1. Remove the gasket from the water pump.


11. REMOVE NO. 2 IDLER PULLEY

NOTICE:
Use the same procedure for both No. 2 idler pulleys.

  1. w/ Idler Pulley Cover Plate:

    1. A191314E01
      Remove the bolt, No. 2 idler pulley cover plate, idler pulley and idler pulley cover plate.

  1. w/o Idler Pulley Cover Plate:

    1. A191315E01
      Remove the bolt, No. 2 idler pulley cover plate and idler pulley.

  1. A076338E01
    for Integrated Type:
    Remove the 2 bolts and 2 No. 2 idler pulleys.


12. REMOVE GENERATOR ASSEMBLY

A122806
  1. Remove the nut and generator wire.

  1. Disconnect the generator connector.

  1. Remove the 2 bolts and generator.


13. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

A076445E01
  1. Remove the 5 bolts and V-ribbed belt tensioner.


14. REMOVE WATER PUMP ASSEMBLY

A072954E01
  1. Remove the 17 bolts, water pump and gasket.

← COMPONENTS (from Jun 2011)REMOVAL (from Aug 2012) →