REMOVAL
Removal / installation · Vehicles built from Aug 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
| 1.
DISCONNECT NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 1 ENGINE UNDER COVER |
 |
Remove the 4 bolts and under cover.
| 3.
DRAIN ENGINE COOLANT
|
 |
Remove the radiator cap.
Loosen the cylinder block drain cock plug and radiator drain plug, and then the coolant.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.


| 4.
REMOVE V-BANK COVER
|
 |
- Remove the 2 nuts and the V-bank cover.
| 5.
DISCONNECT RADIATOR HOSE INLET |
|
| 6.
DISCONNECT RADIATOR HOSE OUTLET |
|
| 7.
REMOVE FAN SHROUD |
 |
Disconnect the radiator reservoir hose from the radiator tank upper.
Loosen the 4 nuts holding the fluid coupling fan.
Remove the driver belt (Click here).
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
- NOTICE:
- Be careful not to damage the radiator core.
Remove the fan pulley from the water pump.
| 8.
DISCONNECT NO. 2 VENTILATION HOSE
|
 |
| 9.
REMOVE AIR CLEANER ASSEMBLY
|
 |
- Disconnect the vacuum hose.
Disconnect the MAF meter connector.
Remove the 2 wire harness clamps.
- Loosen the 2 hose clamps.
Remove the 2 bolts and air cleaner.
| 10.
REMOVE WATER INLET HOUSING |
 |
Disconnect the 2 radiator hoses.
- Disconnect the 5 water by-pass hoses.
- Remove the 5 bolts and water inlet.
Remove the O-ring from the water outlet pipe.
Remove the gasket from the water pump.
| 11.
REMOVE NO. 2 IDLER PULLEY
|
 |
- NOTICE:
- Use the same procedure for both No. 2 idler pulleys.
w/ Idler Pulley Cover Plate:
- Remove the bolt, No. 2 idler pulley cover plate, idler pulley and idler pulley cover plate.
w/o Idler Pulley Cover Plate:
- Remove the bolt, No. 2 idler pulley cover plate and idler pulley.
- for Integrated Type:
Remove the 2 bolts and 2 No. 2 idler pulleys.
| 12.
REMOVE GENERATOR ASSEMBLY |
 |
- for DENSO Made:
(Click here)
- for BOSCH Made:
(Click here)
| 13.
REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
|
 |
Remove the 5 bolts and V-ribbed belt tensioner.
| 14.
REMOVE WATER PUMP ASSEMBLY |
 |
Remove the 17 bolts, water pump and gasket.