REMOVAL
Removal / installation · Vehicles built from Aug 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
- HINT:
- If the thermostat was not installed, cooling efficiency would be harmed. Even if the engine tends to overheat, do not remove the thermostat.
| 1.
REMOVE NO. 1 ENGINE UNDER COVER |
 |
Remove the 4 bolts and under cover.
| 2.
DRAIN ENGINE COOLANT
|
 |
Remove the radiator cap.
Loosen the cylinder block drain cock plug and radiator drain plug, and then the coolant.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.


| 3.
REMOVE V-BANK COVER
|
 |
- Remove the 2 nuts and the V-bank cover.
| 4.
DISCONNECT RADIATOR HOSE OUTLET |
|
| 5.
REMOVE WATER INLET HOUSING WITH THERMOSTAT |
 |
- Remove the 3 nuts, water inlet with thermostat and gasket.