2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.


3. REMOVE RADIATOR GRILLE

  1. B277710E01
    Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 clips and 2 screws.

  1. B277711
    Detach the 6 claws and remove the radiator grille.


4. REMOVE RADIATOR SIDE DEFLECTOR LH

  1. A112159
    Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.


5. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.


6. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.

  1. Loosen the 2 cylinder block drain cock plugs and radiator drain plug, and then the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A110401E01


7. DISCONNECT RADIATOR HOSE INLET

8. DISCONNECT RADIATOR HOSE OUTLET

9. DISCONNECT NO. 1 OIL COOLER INLET TUBE (for Automatic Transmission)
  1. Disconnect the inlet tube from radiator tank lower.


10. DISCONNECT NO. 1 OIL COOLER OUTLET TUBE (for Automatic Transmission)
  1. Disconnect the outlet tube from radiator tank lower.


11. REMOVE FAN SHROUD

  1. A110406
    Remove the 3 bolts and oil reservoir.

  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.


12. REMOVE RADIATOR ASSEMBLY

  1. A112139
    Disconnect the 2 front airbag sensor connectors.

  1. Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.

    HINT:
    Tape the clip remover tip before use.

  1. A112140
    Remove the 4 bolts and radiator.

← ON-VEHICLE CLEANING (from Jun 2011)REMOVAL (Aug 2012 – Jul 2013) →