2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.


3. REMOVE RADIATOR GRILLE

  1. B277710E01
    Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 clips and 2 screws.

  1. B277711
    Detach the 6 claws and remove the radiator grille.


4. REMOVE RADIATOR SIDE DEFLECTOR LH

  1. A112159
    Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.


5. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.


6. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.

  1. Loosen the cylinder block drain cock plug and radiator drain plug, and then the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A270641E01


7. DISCONNECT RADIATOR HOSE INLET

8. DISCONNECT RADIATOR HOSE OUTLET

9. DISCONNECT NO. 1 OIL COOLER INLET TUBE
  1. Disconnect the inlet tube from radiator tank lower.


10. DISCONNECT NO. 1 OIL COOLER OUTLET TUBE
  1. Disconnect the outlet tube from radiator tank lower.


11. REMOVE FAN SHROUD

  1. A110406
    Remove the 3 bolts and oil reservoir.

  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.


12. REMOVE RADIATOR ASSEMBLY

  1. A112139
    Disconnect the 2 front airbag sensor connectors.

  1. Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.

    HINT:
    Tape the clip remover tip before use.

  1. A112140
    Remove the 4 bolts and radiator.

← REMOVAL (Aug 2012 – Jul 2013)DISASSEMBLY (Jun 2011 – Jul 2013) →