2014 Hilux · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Jun 2011


1. REMOVE TIMING GEAR COVER OIL SEAL

A058117E01

HINT:
There are 2 methods to remove the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using a screwdriver and hammer, tap out the oil seal.

  1. A058126E01
    If the timing gear cover is installed to the cylinder block:

    1. Using a knife, cut through the oil seal lip.

    2. Using a screwdriver, pry out the oil seal.

      NOTICE:
      Be careful not to damage the crankshaft.


2. REMOVE TIMING GEAR COVER OIL SEAL

A058121E01

HINT:
There are 2 methods to remove the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using a screwdriver and hammer, tap out the oil seal.

  1. A058124E01
    If the timing gear cover is installed to the cylinder block:

    1. Using SST, remove the oil seal.

      SST
      09308-10010  
      09950-40011   (09957-04010)
      09950-60010   (09951-00350)


3. REMOVE REAR ENGINE OIL SEAL

A061819E01
  1. Using a screwdriver and hammer, tap out the oil seal.


4. INSTALL REAR ENGINE OIL SEAL

A253830E01
  1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09518-36030  
    09950-70010   (09951-07100)

  1. Apply MP grease to the oil seal lip.


5. INSTALL TIMING GEAR COVER OIL SEAL

A058118E02

HINT:
There are 2 methods to install the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)

    2. Apply MP grease to the oil seal lip.

  1. A058127E01
    If the timing gear cover is installed to the cylinder block:

    1. Apply MP grease to the oil seal lip.

    2. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)


6. INSTALL TIMING GEAR COVER OIL SEAL

A058119E01

HINT:
There are 2 methods to install the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09214-76011  

    2. Apply MP grease to the oil seal lip.

  1. A058125E01
    If the timing gear cover is installed to the cylinder block:

    1. Apply MP grease to a new oil seal lip.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

      SST
      09214-76011  

← INSPECTION (from Aug 2012)REASSEMBLY (Jun 2011 – Jul 2012) →