Apply a light coat of spindle oil or gasoline to a new O-ring and install it to the fuel pressure regulator.
Install the fuel pressure regulator with the 2 bolts.
Torque:
9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
2.
CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY
Connect the fuel pipe.
Check that there is no damage or contamination in the connected part of the pipe.
Align the axis of the connector with the axis of the pipe. Push the pipe into the connector until the connector makes a "click" sound. If the connection is tight, apply a little amount of fresh engine oil on the tip of the pipe.
After having finished the connection, try to pull apart the pipe and the connector and confirm that they are securely connected.
Install the fuel pipe clamp.
3.
INSTALL INTAKE AIR SURGE TANK
Install a new gasket and the surge tank with the 2 nuts.
Torque:
28 N*m{
286 kgf*cm
, 21 ft.*lbf
}
Using an 8 hexagon wrench, install the 4 bolts.
Torque:
28 N*m{
286 kgf*cm
, 21 ft.*lbf
}
Install the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket.