ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT AIR FUEL RATIO SENSOR (for Sensor 1) |
![]() ![]() |
Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Specified Condition
1 (HT) - 2 (+B)
1.8 to 3.4 Ω at 20°C (68°F)
1 (HT) - 4 (AF-)
10 kΩ or higher
| INSPECT AIR FUEL RATIO COMPENSATION SYSTEM |
![]() ![]() |
Measure the voltage between terminals of the ECM.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E16-22 (A1A+) - E17-1 (E1)
Ignition switch ON
3.3 V
E16-22 (A1A+) - E17-1 (E1)
Ignition switch ON
3.0 V
E16-22 (A1A+) - E17-1 (E1)
Ignition switch ON
3.3 V
E16-22 (A1A+) - E17-1 (E1)
Ignition switch ON
3.0 V
- NOTICE:
- Connect test leads from the back side of the ECM connector with the ECM connected.
- HINT:
- Voltage between terminals of the ECM is kept constant regardless of the voltage of the A/F sensor.
Connect the intelligent tester to the DLC3.
Select "DATA MONITOR" - "A/FS B1 S1", "A/FS B2 S1" and "O2S B1 S2" to display the monitor.
Warm up the A/F sensor with the engine speed at 2,500 rpm for approximately 2 minutes.
Keep the engine speed at 2,500 rpm and confirm that the displays of "A/FS B1S1" and "A/FS B2 S1" are similar to the illustration.

- HINT:
- The illustration differs from the real display.
- Only the intelligent tester displays the waveform of the A/F sensor.
- The illustration differs from the real display.
Confirm that the display of "O2S B1 S2" changes between 0 to 1 V with the engine speed at 2,500 rpm.


