INSTALLATION
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() ![]() |
Using SST, install the sensor to the front exhaust pipe.
- SST
- 09224-00010
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
Connect the sensor connector.
| 2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
![]() ![]() |
Using SST, install the sensor to the front exhaust pipe.
- SST
- 09224-00010
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
Connect the sensor connector.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. PERFORM INITIALIZATION |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



