When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
2.
DRAIN ENGINE OIL
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and drain plug.
Install a new gasket and the oil pan drain plug.
Torque:
34 N*m{
347 kgf*cm
, 25 ft.*lbf
}
3.
DRAIN ENGINE COOLANT
CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Apply oil or grease to the threads and tip of SST (center bolt) before using it.
31.
REMOVE TIMING GEAR COVER
NOTICE:
As the fuel supply pump is not installed, the injection gear is loose inside the timing gear case. Do not allow the injection gear to fall.
HINT:
To prevent the injection gear from falling, temporarily install the fuel supply pump.
Remove the 14 bolts and 2 nuts.
Pry the timing gear cover at the locations shown in the illustration and remove the timing gear cover.
NOTICE:
Be careful not to drop the injection gear.
Remove the O-ring from the timing gear case.
32.
REMOVE INJECTION GEAR
Secure the No. 2 idle sub gear to the No. 1 idle gear with a service bolt.
Torque:
8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
NOTICE:
If the bolt hole of the No. 2 idle sub gear is not aligned with the bolt hole of the No. 1 idle gear, rotate the crankshaft counterclockwise to align the bolt holes. Then install the service bolt.
Remove the injection gear.
33.
REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE
Remove the No. 1 crankshaft position sensor plate.
Apply lubricant to the threads and tip of SST (center bolt) before using it.
Remove the 2 nuts and fuel supply pump.
NOTICE:
Do not hold or carry the fuel supply pump by the pipe.
The fuel supply pump must be kept horizontal.
Remove the O-ring.
39.
REMOVE OIL PAN SUB-ASSEMBLY
Remove the 22 bolts and 2 nuts.
Insert the blade of an oil pan seal cutter between the oil pan and cylinder block, cut through the applied sealer and remove the oil pan.
NOTICE:
Do not use the oil pan seal cutter for the area between the oil pan and timing belt case, or for the area between the oil pan and rear oil seal retainer.
Be careful not to damage the oil pan flange.
40.
REMOVE OIL STRAINER SUB-ASSEMBLY
Remove the 2 bolts, 2 nuts, oil strainer and gasket.
41.
REMOVE TIMING GEAR CASE ASSEMBLY
Remove the bolt and No. 1 vacuum transmitting pipe.
Remove the union bolt and 8 bolts.
Pry the timing gear case at the location shown in the illustration and remove the gear case and gasket.