REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window) |
Using a moulding remover, detach the 2 clips and 2 claws and remove the rear power window regulator switch assembly with rear door armrest base panel.

Disconnect the connector.
| 2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
Insert a clip remover between the plate and trim board.

- HINT:
- Tape the clip remover tip before use.
Text in Illustration *1
Protective Tape
Turn the handle clockwise to remove the snap ring, rear door window regulator handle and plate.
| 3. REMOVE DOOR PULL HANDLE |
Remove the screw and door pull handle.

| 4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
Remove the clip and screw.

Detach the 9 clips and remove the rear door trim board.
| 5. REMOVE REAR DOOR OUTER GLASS WEATHERSTRIP LH |
Put protective tape around the rear door outer glass weatherstrip.

Text in Illustration *1
Protective Tape
Detach the 4 claws and remove the rear door outer glass weatherstrip.
