2014 Hilux · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

  1. B277098
    Using a moulding remover, detach the 2 clips and 2 claws and remove the rear power window regulator switch assembly with rear door armrest base panel.

  1. Disconnect the connector.


2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

  1. B277021E01
    Insert a clip remover between the plate and trim board.

    HINT:
    Tape the clip remover tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. Turn the handle clockwise to remove the snap ring, rear door window regulator handle and plate.


3. REMOVE DOOR PULL HANDLE

  1. B277099
    Remove the screw and door pull handle.


4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B277100
    Remove the clip and screw.

  1. Detach the 9 clips and remove the rear door trim board.


5. REMOVE REAR DOOR OUTER GLASS WEATHERSTRIP LH

  1. B278870E01
    Put protective tape around the rear door outer glass weatherstrip.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 4 claws and remove the rear door outer glass weatherstrip.

← REMOVAL (Jun 2011 – Jul 2012)REMOVAL (from Aug 2013) →