2014 Hilux · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. REMOVE STEERING PAD ASSEMBLY

  1. B281336E01
    Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
    Text in Illustration 
    *1
    Screw Case

  1. B277210
    Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the connector and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


4. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel assembly set nut.

  1. C238699E03
    Put matchmarks on the steering wheel assembly and steering main shaft.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.


5. REMOVE STEERING COLUMN COVER LOWER

G039357E01
  1. Remove the 3 screws and cover lower.


6. REMOVE STEERING COLUMN COVER UPPER

G039357E01
  1. Remove the 3 screws and cover lower.


7. REMOVE SPIRAL CABLE SUB-ASSEMBLY

B110259E01
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.


8. REMOVE WIPER AND WASHER SWITCH

  1. E225945
    Disconnect the connectors.

  1. Detach the claw and remove the windshield wiper switch.

    NOTICE:
    Do not push the claw with excessive force as damage may occur.


9. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

  1. B087887
    Disconnect the connector.

  1. B113202
    Using needle-nose pliers, remove the band clamp as shown in the illustration.

  1. B085631
    Using a screwdriver, detach the claws and remove the switch.

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (Jun 2011 – Jul 2013)INSPECTION (from Jun 2011) →