2014 Hilux · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
  1. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.

  1. E225838
    Using an air riveter or hand riveter, install the speaker with 3 new rivets.

    NOTICE:

    1. B171664E19
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
      Text in Illustration 
      *1
      Mandrel
      *2
      Riveter
      *a
      INCORRECT
      *b
      CORRECT

    2. B172390E19
      Confirm that the rivets are seated properly against the speaker.
      Text in Illustration 
      *1
      Riveter
      *a
      INCORRECT
      *b
      CORRECT
    3. Do not tilt the riveter when installing the rivet to the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. B172391E17
      Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.
      Text in Illustration 
      *1
      Riveter
      *a
      INCORRECT
      *b
      CORRECT

  1. Connect the connector.


2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. for Double Cab:

    1. Attach the 8 clips to install the front door trim board.

    2. Install the screw and clip.

  1. for Single Cab, for Extra Cab:

    1. Attach the 9 clips to install the front door trim board.

    2. Install the screw and clip.


3. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Window)
  1. Connect the connector.

  1. Attach the 4 claws and 2 clips to install the power window regulator switch assembly with front door armrest base panel.


4. INSTALL DOOR PULL HANDLE
  1. Install the door pull handle with the screw.


5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
  1. Temporarily install the front door window regulator handle, fully close the window, and then remove the front door window regulator handle.

  1. B278578E01
    Install the plate and snap ring to the front door window regulator handle.

  1. Install the front door window regulator handle to the front door window regulator as shown in the illustration.

    Text in Illustration 
    *1
    Snap Ring
    *2
    Plate
    *a
    Front Side

    Standard:
    Area
    Specified Condition
    A
    18 to 42°


6. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
  1. Install the speaker with the screw.

  1. Connect the connector.


7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
  1. Attach the 2 clips to install the front door lower frame bracket garnish.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →