Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.
INSTALL REAR SPEAKER ASSEMBLY
Hold the speaker to the panel.
Install the speaker with the 3 screws.
Connect the connector.
2.
INSTALL QUARTER INSIDE TRIM BOARD LH
Attach the 7 clips, 3 guides and 4 claws to install the quarter inside trim board.
Connect the front seat outer belt floor anchor with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
3.
INSTALL FRONT DOOR OPENING TRIM LH
Align the paint mark on the front door opening trim with the mark position on the vehicle and install the front door opening trim as shown in the illustration.
Text in Illustration
*1
Paint Mark
*2
Mark Position
4.
INSTALL FRONT DOOR SCUFF PLATE LH
Attach the 4 clips and 8 claws to install the front door scuff plate.
5.
INSTALL REAR SEATBACK ASSEMBLY
Place the rear seatback assembly in the cabin.
NOTICE:
Be careful not to damage the vehicle body.
Attach the 2 hooks to the vehicle body.
Install the rear seatback assembly with the 2 bolts.
Torque:
39 N*m{
398 kgf*cm
, 29 in.*lbf
}
6.
INSTALL LOWER BACK PANEL GARNISH
Attach the 5 clips, 2 guides and 6 claws to install the lower back panel garnish.