2014 Hilux · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. INSTALL REAR SPEAKER ASSEMBLY

  1. B085615
    Hold the speaker to the panel.

  1. Install the speaker with the 3 screws.

  1. Connect the connector.


2. INSTALL QUARTER INSIDE TRIM BOARD LH
  1. Attach the 7 clips, 3 guides and 4 claws to install the quarter inside trim board.

  1. Connect the front seat outer belt floor anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


3. INSTALL FRONT DOOR OPENING TRIM LH

B276973E01
  1. Align the paint mark on the front door opening trim with the mark position on the vehicle and install the front door opening trim as shown in the illustration.

    Text in Illustration 
    *1
    Paint Mark
    *2
    Mark Position


4. INSTALL FRONT DOOR SCUFF PLATE LH
  1. Attach the 4 clips and 8 claws to install the front door scuff plate.


5. INSTALL REAR SEATBACK ASSEMBLY

  1. B276916
    Place the rear seatback assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Attach the 2 hooks to the vehicle body.

  1. Install the rear seatback assembly with the 2 bolts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 in.*lbf }


6. INSTALL LOWER BACK PANEL GARNISH
  1. Attach the 5 clips, 2 guides and 6 claws to install the lower back panel garnish.


7. INSTALL REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)

  1. B288345
    Attach the 2 hooks.

  1. B288346
    Attach the hook to install the rear seat cushion assembly LH.


8. INSTALL REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)

HINT:
Use the same procedures described for the LH side.


9. INSTALL UPPER BACK PANEL GARNISH
  1. Attach the 5 clips and 4 claws to install the upper back panel garnish.


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSTALLATION (Aug 2012 – Jul 2013)COMPONENTS (from Jun 2011) →