2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL INTERCOOLER ASSEMBLY

  1. A149932
    Install a new gasket and the intake air connector with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. A135919
    Install the intercooler with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. A149934
    Install a new No. 2 air hose and then tighten the 2 hose clamps.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }

  1. A149933
    Tighten the 2 hose clamps of the No. 1 air hose.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }


2. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR

  1. A150479
    Install the sensor with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Attach the 2 clamps and connect the sensor connector.


3. INSTALL INTAKE AIR TEMPERATURE SENSOR
  1. Using a 22 mm deep socket wrench, install a new gasket and the IAT sensor.

    Torque:
    34 N*m{ 350 kgf*cm , 25 ft.*lbf }

  1. A135914
    Connect the IAT sensor connector.


4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

A135916
  1. Install the engine cover with the 3 bolts and 2 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →