2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011

NOTICE:
Do not remove the electric vacuum regulating valve.


INSPECT ELECTRIC VACUUM REGULATING VALVE

  1. A151146E01
    Apply a vacuum measure the resistance of the electric vacuum regulating valve (E-VRV).

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    11 to 13 Ω at 20°C (68°F)
    1 - Body Ground
    2 - Body Ground
    10 MΩ or higher

    If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.

  1. A151813E02
    Check operation of the E-VRV.

    1. When a vacuum of 66.7 kPa (500mmHg, 19.7 in.Hg) is applied to the port E, check that air flows from port F to the filter.
      If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.

    2. A151148E01
      Apply battery voltage across terminals 1 and 2.

    3. Check that air flows from port F to port E.
      If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.

← REMOVAL (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →