2014 Hilux · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH
  1. Connect the connector.

  1. Install the side turn signal light assembly LH with the 2 screws.


2. INSTALL OUTER MIRROR COVER LH

  1. B280807E02
    Attach the 3 claws as shown in the illustration.

  1. Attach the 6 claws to install the mirror cover LH.

  1. B280811E01
    After installing the outer mirror cover, check that there is no gap between the cover and mirror body.

    HINT:
    If there is a gap between the cover and body, noise will occur during driving.


3. INSTALL OUTER MIRROR LH

B278453
  1. Install the outer rear view mirror assembly LH with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 ft.*lbf }

  1. w/ Power Mirror Control System:
    Connect the connector.


4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
(Click here)
← INSPECTION (from Jun 2011)COMPONENTS (Jun 2011 – Jul 2013) →