1.
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH (w/ Power Window)
Using a moulding remover, detach the 2 clips.
Disconnect the 4 claws and remove the power window regulator master switch assembly with front door armrest base panel.
Text in Illustration
*A
for Double Cab
*B
for Single Cab, for Extra Cab
2.
REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (w/ Power Window)
Using a moulding remover, detach the 2 clips.
Disconnect the 4 claws and remove the power window regulator switch assembly with front door armrest base panel.
3.
REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
Insert a clip remover between the plate and trim board.
HINT:
Tape the clip remover tip before use.
Text in Illustration
*1
Protective Tape
Turn the handle counterclockwise to remove the snap ring, front door window regulator handle and plate.
4.
REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
Detach the 2 clips and remove the front door lower frame bracket garnish.
Text in Illustration
*A
w/o Front No. 2 Speaker
*B
w/ Front No. 2 Speaker
5.
REMOVE DOOR PULL HANDLE
Remove the screw and door pull handle.
6.
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
for Double Cab:
Remove the clip and screw.
Text in Illustration
*1
Clip
*2
Screw
Detach the 8 clips and remove the front door trim board.
for Single Cab, for Extra Cab:
Remove the clip and screw.
Text in Illustration
*1
Clip
*2
Screw
Detach the 9 clips and remove the front door trim board.
7.
REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
w/ Power Mirror Control System: Disconnect the mirror connector.
Remove the 3 nuts.
Push down the claw and remove the outer rear view mirror assembly LH.
8.
REMOVE OUTER MIRROR LH
Using a screwdriver, detach the 2 claws as shown in the illustration.
Text in Illustration
*1
Screwdriver
*2
Protective Tape
NOTICE:
Do not pull the outer mirror LH with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
HINT:
Apply protective tape to the mirror body and screwdriver tip.
Detach the 2 claws at the upper part of the outer mirror.
Remove the outer mirror LH.
9.
REMOVE OUTER MIRROR COVER LH (w/ Side Turn Signal Light)
Remove the tape.
Text in Illustration
*1
Tape
Remove the screw, detach the 5 claws and remove the rubber base.
HINT:
It is not necessary to completely remove the rubber base. Slightly move the rubber base so that the outer mirror cover LH can be removed in a later step.
Using a T25 "TORX" socket wrench, remove the 3 screws.
Using a T25 "TORX" socket wrench, remove the screw.
Remove the 3 screws.
Detach the 6 claws.
Detach the 2 claws and remove the outer mirror cover LH as shown in the illustration.
10.
REMOVE OUTER MIRROR COVER LH (w/o Side Turn Signal Light)
Using a screwdriver, detach the 6 claws.
HINT:
Tape the screwdriver tip before use.
Detach the 3 claws as shown in the illustration and remove the outer mirror cover LH.