2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


REMOVE OIL PUMP COVER

  1. A072931E01
    Remove the 3 bolts and oil pipe.

  1. Remove the 2 O-rings.

  1. A072932E01
    Remove the 7 bolts, oil pump cover, drive rotor and driven rotor.


REMOVE OIL PUMP RELIEF VALVE
  1. Remove the plug, spring and relief valve.


INSPECT OIL PUMP RELIEF VALVE

  1. A072933E01
    Coat the valve with the engine oil and check that it falls smoothly into the valve hole by its own weight.
    If the does not, replace the relief valve. If necessary, replace the oil pump assembly.


INSPECT OIL PUMP ROTOR SET

  1. A072934E01
    Place the drive and driven rotors into the timing chain cover with the marks facing upward.

  1. A072936E01
    Inspect the rotor tip clearance.

    1. Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

      Tip clearance:
      Condition
      Clearance
      Standard
      0.06 to0.16 mm (0.0024 to 0.0063 in.)
      Maximum
      0.16 mm (0.0063 in.)

      If the tip clearance is greater than the maximum, replace the rotor as a set.

  1. A072937E02
    Inspect the rotor side clearance.

    1. Using a feeler gauge and precision straightedge, measure the clearance between the rotors and straightedge, as shown in the illustration.

      Side clearance:
      Condition
      Clearance
      Standard
      0.03 to 0.09 mm (0.0012 to 0.0035 in.)
      Maximum
      0.09 mm (0.0035 in.)

      If the side clearance is greater than the maximum, replace the rorors as a set. If necessary, replace the timing chain cover assembly.

  1. A072935E01
    Inspect rotor body clearance.

    1. Using a feeler gauge, measure the clearance between the driven roror and body.

      Body clearance:
      Condition
      Clearance
      Standard
      0.250 to 0.325 mm (0.00098 to 0.0128 in.)
      Maximum
      0.325 mm (0.0128 in.)

      If the body clearance is greater than the maximum, replace the rotors as a set. If necessary, replace the timing chain cover assembly.


INSTALL OIL PUMP RELIEF VALVE

  1. A072934E01
    Coat the relief valve with engine oil and insert the relief valve and spring into the valve hole.

  1. Install the relief valve plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


INSTALL OIL PUMP COVER
  1. Apply new engine oil to the drive and driven rorors.

  1. Place the drive and driven rotors into the timing chain cover with the marks facing the oil pump cover side.

  1. A072932E01
    Install the oil pump cover with the 7 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Install a new O-ring to the oil pump cover.

  1. Install a new O-ring to the oil pipe.

  1. A072931E01
    Install the oil pipe with the 3 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

← REMOVAL (from Aug 2013)INSTALLATION (Jun 2011 – Jul 2012) →