INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT OIL CLEARANCE |
Using a micrometer, measure the diameter (a) of the shaft sub-assembly with pulley.

Using a caliper gauge, measure the inside diameter (b) of the vane pump housing front.
- NOTICE:
- Do not damage the bushing in the vane pump housing front.
Subtract (a) from (b) to calculate the oil clearance.
- Maximum clearance:
- 0.07 mm (0.0028 in.)
| INSPECT VANE PUMP ROTOR AND VANE PLATES CLEARANCE |
Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane plates.

- Maximum clearance:
- 0.03 mm (0.0012 in.)
- NOTICE:
- If the clearance is more than the maximum, replace the vane plates, vane pump rotor and vane pump cam ring.
- Refer to the following table to select an appropriate combination of vane pump rotor, vane pump cam ring and vane plates.
- Combination of vane pump rotor, vane pump cam ring and vane plates:
Vane Pump Rotor Part No.
Vane Pump Cam Ring Part No.
Vane Plate Part No.
44313-06110
44325-06160
44345-06110
44313-06120
44325-06170
44345-06120
44313-06130
44325-06180
44345-06130
44313-06140
44325-06190
44345-06140
44313-06150
44325-06200
44345-06150
- If the clearance is more than the maximum, replace the vane plates, vane pump rotor and vane pump cam ring.
| INSPECT FLOW CONTROL VALVE |
Check the flow control valve for leakage. Close one of the holes and apply compressed air of 392 to 490 kPa (4 to 5 kgf/cm2, 57 to 71 psi) to the hole on the opposite side. Confirm that the air does not flow out of the end holes.

- NOTICE:
- Make sure to use clean and dry air.
If there is leakage, replace the flow control valve.

- NOTICE:
- Check the mark on the vane pump housing front and replace the flow control valve with one having the same mark as that of the vane pump housing front.
- Refer to the following table to select an appropriate combination of vane pump housing front and flow control valve.
- Combination of vane pump housing front and flow control valve:
Vane Pump Housing Front Mark
Flow Control Valve Mark
Flow Control Valve Part No.
A
A
44330-0K010
B
B
44330-0K020
C
C
44330-0K030
D
D
44330-0K040
E
E
44330-0K050
F
F
44330-0K060
- Check the mark on the vane pump housing front and replace the flow control valve with one having the same mark as that of the vane pump housing front.
Coat the flow control valve with power steering fluid.
- NOTICE:
- Make sure to use new power steering fluid.
Insert the flow control valve into the flow control valve installation hole of the vane pump housing front, and check that the flow control valve enters smoothly under its own weight.

If the flow control valve does not enter the vane pump housing front smoothly, replace the flow control valve.
| INSPECT COMPRESSION SPRING |
![]() ![]() |
Using a vernier caliper, measure the free length of the spring.
- Minimum free length:
- 29.2 mm (1.150 in.)
| INSPECT PRESSURE PORT UNION SUB-ASSEMBLY |
If the union seat in the pressure port union sub-assembly is severely damaged, replace the pressure port union sub-assembly.

