2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL GLOW PLUG ASSEMBLY

  1. A118420
    Using a 12 mm deep socket wrench, install the 4 glow plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }


2. INSTALL NO. 1 GLOW PLUG CONNECTOR
  1. Install the glow plug connector by uniformly tightening the 4 nuts.

    Torque:
    1.0 N*m{ 10 kgf*cm , 9 in.*lbf }

  1. Install the 4 screw grommets.

  1. Install the wire harness with the nut.

    Torque:
    8.4 N*m{ 85 kgf*cm , 74 in.*lbf }


3. INSTALL INTAKE PIPE ASSEMBLY

  1. A118426
    Install the intake pipe with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Tighten the 2 intake pipe clamps.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

← REMOVAL (from Jun 2011)INSTALLATION (Aug 2012 – Jul 2013) →