2014 Hilux · Service Manual TRANSMISSION

L4 Position Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

The No. 1 transfer indicator switch (L4 position switch) detects the gear position of the transfer shift lever.
Moving the transfer shift lever to L4 turns the L4 position switch ON. Then the TCM cancels operation of the lock-up clutch.

WIRING DIAGRAM

C154998E31

INSPECTION PROCEDURE


1. INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
A110992E01
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
OK


2. CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - TCM AND BODY GROUND)
G034868E05
  1. Disconnect the T4 switch connector.

  1. Disconnect the T37 TCM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T37-15 (L4) - T4-1
    Below 1 Ω
    T4-2 - Body ground
    Below 1 Ω
    T37-15 (L4) or T4-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Stop Light Switch Circuit (from Jun 2011)A/T P Indicator Circuit (Jun 2011 – Jul 2012) →