The propeller shaft and wheels are free even when the transmission shift lever is on P, as long as the transfer shift lever is on N. The A/T P indicator illuminates to warn the driver that the propeller shaft and wheels are not locked. If the A/T P indicator illuminates, the transfer shift lever should be moved from N.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH
Disconnect the N8 park/neutral position switch connector.
Measure the resistance of the park/neutral position switch when the shift lever is moved to each position.
Standard resistance:
Tester Connection
Shift Lever Position
Specified Condition
4 (B) - 5 (L)
P or N
Below 1 Ω
4 (B) - 5 (L)
Not on P or N
10 kΩ or higher
1 (RL) - 2 (RB)
R
Below 1 Ω
1 (RL) - 2 (RB)
Not on R
10 kΩ or higher
2 (RB) - 7 (DL)
D
Below 1 Ω
2 (RB) - 7 (DL)
Not on D
10 kΩ or higher
2 (RB) - 3 (2L)
2
Below 1 Ω
2 (RB) - 3 (2L)
Not on 2
10 kΩ or higher
2 (RB) - 8 (LL)
L
Below 1 Ω
2 (RB) - 8 (LL)
Not on L
10 kΩ or higher
NG
REPLACE PARK/NEUTRAL POSITION SWITCH
OK
2. INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
Remove the transfer indicator switch.
Measure the resistance of the switch when pushing the ball at the tip of the switch.
Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Not pushed
10 kΩ or higher
1 - 2
Pushed
Below 1 Ω
NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
OK
3. INSPECT COMBINATION METER
Check the A/T P indicator light.
Disconnect the T5 switch connector.
Turn the ignition switch ON.
Connect the T5-1 terminal of the wire harness side connector to the body ground, and then check the A/T P indicator light.