2014 Hilux · Service Manual TRANSMISSION

TCM Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

When the ignition switch is turned ON, battery voltage is applied to terminal IG2 of the TCM.

WIRING DIAGRAM

C190897E05

INSPECTION PROCEDURE


1. INSPECT FUSE (IGN)
A111770E01
  1. Remove the IGN fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard Resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT IGNITION SWITCH

  1. C192934E01
    Disconnect the I6 ignition switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (AM2) - 6 (IG2)
    OFF
    10 kΩ or higher
    5 (AM2) - 6 (IG2)
    ON
    Below 1 Ω



NG
REPLACE IGNITION SWITCH
OK


3. CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)

  1. C191544E08
    Disconnect the T19 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK TCM (TCM - BATTERY)
C191543E25
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    T38-6 (IG2) - T19-1 (E1)
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM


← U0100 Lost Communication with ECM / PCM "A" (from Jun 2011)PRECAUTION (from Jun 2011) →