2014 Hilux · Service Manual TRANSMISSION

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2012

DESCRIPTION

When the ignition switch is turned to ON, battery voltage is applied to terminal IG2 of the TCM.

WIRING DIAGRAM

C190897E14

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT IGNITION SWITCH

  1. C241948E01
    Disconnect the ignition switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (AM2) - 6 (IG2)
    LOCK
    10 kΩ or higher
    5 (AM2) - 6 (IG2)
    ON
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Ignition switch)



NG
REPLACE IGNITION SWITCH
OK


2. CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)

  1. C274533E35
    Disconnect the TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to TCM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK TCM (TCM - BATTERY)
  1. Turn the ignition switch to ON.

  1. C212050E29
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    T38-6 (IG2) - T19-1 (E1)
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Component with harness connected
    (TCM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM


← U0100 Lost Communication with ECM / PCM "A" (from Aug 2014)PRECAUTION (from Jun 2011) →