P0560 System Voltage
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
While the ignition switch is OFF, battery voltage is supplied to terminal BATT of the ECM for storing DTCs and fuel injection feedback learning values.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0560 |
Condition (a) or (b) continues: (a) Significant decrease in battery voltage (b) Open in back-up power source circuit (1 trip detection logic) |
|
- HINT:
- If DTC P0560 appears, the ECM does not store other DTCs.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the ECM is replaced, the new ECM needs registration (Click here) and initialization (Click here).
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. CHECK FUSE (EFI FUSE) |
Remove the EFI fuse from the engine room junction block.

Measure the resistance of the EFI fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK ECM (BATT VOLTAGE) |
Measure the voltage of the E7 and E6 ECM connectors.

- Standard voltage:
Tester Connection
Specified condition
E6-2 (BATT) - E7-7 (E1)
11 to 14 V
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (ECM - EFI FUSE, EFI FUSE - BATTERY) |
Check the harness and the connector between the EFI fuse and ECM.

Disconnect the E6 ECM connector.
Remove the EFI fuse from the engine room junction block.
Measure the resistance.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
E6-2 (BATT) - 2 (EFI fuse)
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Specified Condition
E6-2 (BATT) or 2 (EFI fuse) - Body ground
10 kΩ or higher
Check the harness and the connector between the EFI fuse and battery.
Remove the EFI fuse from the engine room junction block.
Disconnect the positive battery terminal.
Measure the resistance.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
Battery positive terminal - EFI fuse (1)
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Specified Condition
Battery positive terminal or EFI fuse (1) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK BATTERY |
Check that the battery is not depleted.
- OK:
- Battery is not depleted
|
|
||||
| OK | ||
| ||
