P0607 Control Module Performance
Diagnostic trouble codes · Vehicles built from Aug 2014
Also covers:
- P1611 IC Circuit Malfunction
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Detection Drive Pattern |
DTC Detection Condition |
Trouble Area |
| Ignition switch to ON for 1 second |
ECM internal error (1 trip detection logic) |
ECM |
| DTC Detection Drive Pattern |
DTC Detection Condition |
Trouble Area |
| Ignition switch to ON for 1 second |
ECM internal error (1 trip detection logic) |
ECM |
INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0607 AND/OR P1611) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
Result Result
Proceed to
P0607 or P1611
A
P0607 or P1611 and other DTCs
B
|
|
||||
| A | |
| 2. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 3. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||
