2014 Hilux · Service Manual ENGINE

P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Refer to DTC P0105 (Click here).
DTC No.
DTC Detection Condition
Trouble Area
P0106
Voltage output of the manifold absolute pressure sensor is out of the standard range
(2 trip detection logic)
Manifold absolute pressure sensor

INSPECTION PROCEDURE

HINT:
If DTCs P0105, P0107, and P0108 are output simultaneously, the manifold absolute pressure sensor circuit may have an open or short. Perform troubleshooting for these DTCs first.


1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0106)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

    Result:
    Display (DTC Output)
    Proceed to
    P0106
    A
    P0106 and other DTCs
    B

    HINT:
    If codes other than P0106 are output, perform troubleshooting for those DTCs first.



B
GO TO DTC CHART
A

REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR


← P0105 Manifold Absolute Pressure / Barometric Pressure Circuit (+ P0107, P0108) (from Aug 2014)P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem (Aug 2012 – Jul 2013) →