2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A118445E02
    Check the rotor for an open circuit.

    1. Measure the resistance between the slip rings.

      Standard resistance:
      1.85 to 2.25 Ω at 20°C (68°F)

      If the result is not as specified, replace the rotor assembly.

  1. A118446E02
    Check if the rotor is grounded.

    1. Measure the resistance between each slip ring and the rotor.

      Standard resistance:
      10 kΩ or higher

      If the result is not as specified, replace the rotor assembly.

  1. Check that the slip rings are not rough or scored.
    If rough or scored, replace the rotor assembly.

  1. A118447E01
    Using a vernier caliper, measure the diameter of each slip ring.

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the rotor assembly.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

A079305E02
  1. Using a vernier caliper, measure the exposed brush length.

    Standard exposed length:
    10.5 mm (0.413 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    If the exposed length is less than the minimum, replace the brush holder assembly.


INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A122145
    Check that the bearing is not rough or worn, and that it rotates smoothly.
    If necessary, replace the generator drive end frame bearing.


INSPECT GENERATOR ROTOR BEARING

  1. A118444
    Check that the bearing is not rough or worn, and that it rotates smoothly.
    If necessary, replace the generator rotor assembly.


INSPECT GENERATOR PULLEY WITH CLUTCH
  1. When rotating the pulley, check that it turns clockwise and that it does not turn counterclockwise.
    If the result is not as specified, replace the generator pulley with clutch.

← DISASSEMBLY (from Jun 2011)REPLACEMENT (from Jun 2011) →